Alcorn Mcbride Light Cue Manual do Utilizador descarregar pdf (Página 22)

Page 22 Alcorn McBride Light Cue User’s Manual • November 26, 2007

Select Cue

Description: This command causes the Light Cue to select the specified cue

number for play. Once this command is sent, the next Play

command causes the specified cue to play from the beginning of the

file. The unit defaults to cue #1 at power-up.

Command Bytes: nSE<CR> or nnSE<CR> or nnnSE<CR>

where n, nn, or nnn is the cue number in ASCII.

Message Response: R<CR>

Comments: This is similar to the “Search to Address” command in chapter

addressing mode used in Pioneer Laser Disc protocol. The

maximum cue number is 511.

Examples: Select cue 215. "215SE"<CR>

Select cue 4. "4SE"<CR>

Play

Description: This command causes the Light Cue to play the cue that was

specified with the “Select Cue” command. Bytes are included for

crossfade time from the current look to the first look of the selected

cue. This command is used when no SMPTE synchronization is

required. The crossfade time specified will override any that had

been selected during recording of the cue.

Command bytes: hhmmssffPL<CR>

where hhmmssff is the crossfade time in hours, minutes, seconds,

and frames. Leading 0's are required (see example).

Message Response: R<CR>

Examples:

1. Play with crossfade time of 00:00:03.15

"00000315PL" <CR>

2. Play with crossfade time of 00:01:10.20

"00011020PL" <CR>

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 30 31

Sem comentários

Alcorn Mcbride Light Cue Manual do Utilizador Página 22